Epson PowerLite 77c Front Remote Sensor Replacement

ID: 149183

Description: The front remote sensor on the Epson PowerLite...

Steps:

  1. Use a Phillips #0 screwdriver to remove the seven 5.0 mm screws on the base panel.
  2. Pick up the projector with both hands, sandwiching the top and bottom of the projector together, and place it right-side-up, with the ports facing you.
  3. Lift the top panel up.
  4. Two connectors are holding the top panel to the motherboard; be careful not to damage them as you lift the top panel.
    5. Step image
  5. Flip the locking bar of the ZIF connector vertically, then delicately remove the ribbon cable.
  6. Grip the cable connector as close as possible to the plug, then pull it straight up until it releases from the motherboard.
  7. Remove the top panel.
    8. Step image Step image
  8. Grip the front remote sensor's white plug and gently pull directly upwards until the plug releases.
    9. Step image
  9. Lift the remote sensor up and out of the projector.
    10. Step image
Back