How to Repair a Trophy
ID: 149341
Description: Over the years, dust, dirt and poor treatment...
Steps:
- Put the cylindrical tube on the small threaded rod of the cup.
- Turn to the right until you tighten it completely.
- Place the longest threaded rod on the opposite side of the cylindrical tube and twist again to the right until it is tight.
- Put all the pieces on in the correct order.
- If you put them on in the wrong order they won't fit.
- Insert the nut into the hub of the 3/8 drive ratchet wrench.
- Use the 3/8 inch ratchet wrench to secure the nut at the bottom of the trophy. Turn the nut clockwise until it is fully secure.
- Glue the remaining two pieces to the side of the trophy.
- Allow them to dry before touching to prevent them from coming off.
- Wait some time (approximately 30 minutes) until the pieces have dried completely.
- And your done!!
