HP Envy x360 15m-bq021dx Power Input Replacement

ID: 149402

Description: If your HP Envy x360 15m-bq021dx (also known as...

Steps:

1. On the back panel of the device, remove the four (4) M2.5xL6 screws at the top of the photo using a Phillips #0 screwdriver.
2. Unscrew the three (3) screws at the bottom of the photo using a T5 Torx screwdriver.

3. To remove the back cover, use the black spudger to lift up on the edges of the cover.
4. Use a suction cup to assist in lifting the back cover

5. Use the Philips #0 screwdriver to remove six (6) M2.0x3.2 screws from battery.

6. Using the Philips #0 screwdriver, remove the final screw from the battery connected to the SSD storage unit.

7. Lift and pull the front of the battery up and out (away from the connector) to remove.

8. Using a Philips #0 screwdriver, remove the three M2x4 screws located around the cooling fan as shown in this picture.
9. Be careful as the fan might be sharp in some places when removing it.

10. Remove the connector clip with the tweezers.

11. Remove the four spring loaded screws with a Philips #1 screwdriver.

12. Remove the cooling fan.

13. Using a Phillips #1, remove the seven M2.0x3.2 screws.
14. Undo the six connections using the blue opening tool.

15. Carefully remove the aux port from the frame of the computer as shown.

16. Pull the mother board up and away from frame of the computer.

17. Use the tweezers to remove the cords from their restraints.
18. Lift the speakers out of the laptop.

19. Remove the three M2.0x3.2 hinge screws next to the power input cord using a Philips #0 screwdriver.
20. Pry the hinge up so that it is out of the way.

21. Lift out the power input.