Epson PowerLite 822 Plus Exhaust Fan Replacement

ID: 149505

Description: This is a replacement guide for the exhaust fan...

Steps:

1. Flip the projector over.
2. Remove all 8 screws on the bottom of the projector.

3. Now, flip the projector back over and pry the top of it open revealing the inside of the projector.

4. Use the spudger to disconnect it from the motherboard.

5. Using your finger gently move back and forth the JST cable that connects the top to the motherboard.
6. Now completely take off the top of the projector.

7. Remove the 3 screws that secure the motherboard in place.

8. Gently move back and forth the 11 JST connectors until they come out.

9. With the spudger lift the red plastic tabs from their connectors.

10. Lift the motherboard and disconnect the JST connector underneath.

11. Now, the motherboard is completely removed from the projector and you are ready to replace it.

12. Unscrew the four 6mm screws that hold together the fan bracket.

13. Unscrew the four 6mm screws that secure the projector.

14. Pull out the loose projector.

15. Gently lift the fan bracket up and remove it and it is ready to be replaced.