Vorwerk Kobold VR200 battery exchange/removal

ID: 149679

Description: These instructions are used to replace the...

Steps:

1. Turn off the robot via the "Settings" > "Turn off robot" menu.

2. Turn the robot over and place it on a suitable, soft surface. Make sure that the robot does not lie directly on the dome.
3. Use either two soft wooden slats or a small and sturdy cardboard box.

4. Now remove the two screws 3.5x14mm with a Torx screwdriver T10

5. Now pry open the battery cover with a suitable tool (plectrum or plastic opening tool). Make sure that there are two latches on the opposite side of the screws. The cover must therefore be lifted from the screw-on side.

6. Removing the battery is a bit difficult. One possibility is that you use the plastic opening tool to remove the foam tape on the left and right side of the battery.
7. Then you can use both hands to lift the battery by the "ears" of the tape.

8. Disconnect the 4-pin plug of the battery by first pressing the latch and then pulling out the plug.