Gamesir-G3s Joystick Replacement

ID: 151640

Description: This guide demonstrates how to replace a broken...

Steps:

1. Use a Phillips #00 screwdriver to remove the seven screws securing the back case.
2. Gently pry the rear half of the shell off by hand.

3. Battery can be a hazard if punctured.
4. Use tweezers to slowly pull on the connector while wiggling until it releases from its port.

5. The 600mAh rechargeable battery must be stored safely while you continue with repair.
6. Peel the battery off of the motherboard.
7. Store the battery in a container at room temperature.

8. Use a Phillips #00 screwdriver to remove the two screws that connect the motherboard to the case.

9. Remove the bracket that holds the bumpers in place by gently levering it out of its two holders on both sides.

10. Use a Philips #00 screwdriver to remove 6 screws holding the button panel to the controller.
11. Remove the button panel from the front case.

12. Grab the joystick from the base and then gently pull it up and off.