Cricut Mug Press Teardown

ID: 152947

Description: Need to take apart your mug press? Button got...

Steps:

  1. Place your device to be taken apart on a clean flat surface with plenty of space.
    2. Step image
  2. Remove two plastic screw covers from bottom using a pick tool.
  3. remove two screws using driver.
    4. Step image
  4. Remove the two rubber screw covers and stick them about one inch above the screws.
  5. Remove two screws and place aside.
  6. Press the lever flush and remove upper plastic.
    7. Step image
  7. Remove six screws and place aside
  8. Lift lever and gently remove lower plastic for lever.
    9. Step image
  9. Metal lever bracket needs to be in the up position.
  10. Gently remove the housing careful to not damage the attached power and usb cables
    11. Step image
  11. Switch is held in place with two screws.
  12. If the screws break lose you can replace them with HDD screws
  13. Gently thread two HDD screws until tension holds the board in place and no further.
  14. DO NOT OVER-TIGHTEN SCREWS.
  15. Perform steps in reverse to reassemble being careful to place cables behind the heat shield.
    16. Step image Step image
Back