Titan Airless Sprayer IMPACT 410 Capacitor Replacement

ID: 153203

Description: Use this guide to replace and discharge the set...

Steps:

1. Before you begin, make sure to follow the pressure relief procedure documented in the user manual before powering down the paint sprayer and disconnecting the pump.
2. Turn off and unplug the sprayer.

3. Use a Phillips driver to remove the four 12 mm-long screws (two on either side) securing the motor cover.

4. Pull the motor cover straight off the motor.

5. Use diagonal cutters, or scissors, to cut the two cable ties bundling the capacitor's positive and negative wires.
6. During reassembly, replace the cable ties.

7. Disconnect the black negative wire's spade connector.
8. Always grip cables by their connectors and not the wires themselves.

9. Disconnect the red positive wire's bullet connector.
10. Always grip cables by their connectors and not the wires themselves.

11. Grip the cable tie and slide it off the capacitors.

12. If you have already discharged the capacitors, skip this step.
13. Follow this guide to discharge your capacitors.

14. The capacitors are lightly adhered to the motor body.
15. Insert a flathead screwdriver underneath the capacitors, between the bottom cell and the adhesive.
16. Pry up to separate the bottom cell from the motor body.

17. Insert a flathead screwdriver underneath the capacitors, between the top cell and the adhesive.
18. Pry up to separate the rest of the capacitor from the motor body.
19. Remove the capacitor.
20. During reassembly, if the adhesive is no longer sticky, replace it with double-sided foam adhesive.