Dyson Supersonic HD01 Motor Replacement

ID: 154868

Description: This guide will show you how to replace the...

Steps:

1. Find the red dot along the top of the filter cover.
2. The red dot will be aligned with the white dot at the bottom of the hair dryer's handle.
3. Twist the filter cover counter-clockwise until the red dot is shifted to align with the white empty circle on the dryer handle.

4. Remove the filter cover by sliding it off of the handle.

5. Remove the two retaining screws at the base of the handle using a T6 Screwdriver.

6. Seperate the filter mesh at the plastic seam by pulling it apart.
7. Remove the filter mesh by sliding it off of the handle.

8. Heat the iOpener in the microwave for 30 seconds and apply it immediately to the top of the buttons.
9. Leave the iOpener in place for a couple minutes.

10. Remove the buttons with tweezers.
11. Power button
12. Cold shot button
13. Use a microfiber towel soaked in rubbing alcohol to clean the button holes. Doing this will loosen the buttons if jammed.

14. Pull down the cover of the hair dryer.
15. Roll the 2 O-rings down the handle and out of the way.

16. Pop off the front panel of the hair dryer.
17. Flip the hair dryer 180 degrees to the back panel.
18. Remove the three 10 mm screws located on the back of the hair dryer using a T6 Torx screwdriver.
19. Remove the single T8 screw at the cable end of the back case

20. Flip the hair dryer back to the front panel.
21. Remove the four 10 mm screws on the front using a T4 Torx screwdriver.
22. Remove the back cover of the hair dryer.

23. Slide down the cover of the motor.
24. Disconnect the switch on the metal circular area towards the center of the motor.

25. Disconnect the switch located in the center area of the motor.
26. Slide off the black sheath on the motor.