How to fix mouse wheel clicks on G903

ID: 154926

Description: Although this guide states the soles cannot be...

Steps:

  1. Remove the soles (the aluminosilicate glass feet or slides) to access the screws, then remove them.
  2. Separate the upper and lower case parts by splitting them into two from where they are connected.
  3. If you remove the factory soles, you can't put them back on, so you need to buy them in advance. (See Prequisite guide for removal and replacement of the feet (soles).)
  4. Do not pull too hard when opening the case since the wires inside are still connected.
  5. There are 7 screws in total, 1 near the USB connector and 6 under the soles.
    6. Step image
  6. Remove the pin by pushing it with a thin stick or screwdriver
  7. Lift the wheel to remove it.
    8. Step image
  8. Peel off the Kapton tape on the metal dome switch and take out the metal plate inside
  9. Remove all of the kapton tape
  10. DON'T LOSE IT! Once it's gone, it's almost impossible to find it, (Be careful as it will fly away in the wind).
    11. Step image
  11. Bend so that the center rises by about 0.2mm
  12. Be sure to secure it firmly before proceeding.
  13. Do not bend it too much.
    14. Step image
  14. Put the metal plate back
  15. Affix Kapton tape to fix (if not available, cellotape can be substituted.)
  16. Shape Kapton tape (scotch tape) with a cutter, etc.
    17. Step image
Back