Nintendo NES Advantage Circuit Board Replacement

ID: 155218

Description: If you need to repair any buttons on your...

Steps:

1. Remove the four sticky pads from the bottom of the device.
2. If the pads are stuck, use a spudger to remove them.

3. Remove the six 8 mm screws from the bottom of the device with a Phillips #0 screwdriver.
4. Use your hands to pull the back panel away from the controller.

5. Remove the three 14 mm screws from the gray cross with a Phillips #0 screwdriver.
6. Lift the gray component away from the device.

7. Lift up the black wire and move it to the side.

8. Remove the two silver knobs on the front of the device.
9. Unscrew the two silver nuts using a flathead screwdriver.
10. Remove each silver nut and silver washer using a pair of tweezers.

11. Remove the remaining three 8 mm screws on the circuit board with a Phillips #0 screwdriver.
12. Remove the silver bracket from the top of the circuit board.

13. Remove the circuit board from the controller.