HP Pavilion 15-eg0025nr Screen Replacement

ID: 155251

Description: This guide will show you how to remove your HP...

Steps:

1. Unplug and turn off the laptop before removing the back panel
2. Flip over the computer so that the back panel is facing upwards.
3. Remove the two silver screws on the bottom of the laptop using a Phillips #00 screwdriver.

4. Peel up each end of the two gray rubber stoppers using your fingers or an opening pick.
5. This may be difficult if it is your first time removing them.
6. Remove the two black screws underneath the rubber stoppers with the Phillips #00 screwdriver

7. Slide the opening pick around the edges of the laptop where the chassis has a seam.
8. You will hear a clicking noise as you undo the clips of the chassis.
9. It may be easier to start with the four corners of the laptop, and then follow through with the sides.

10. Remove the back panel completely.
11. With the back panel removed, you can now access parts of the laptop such as the fan or the battery.

12. Remove the five screws from the battery using a Phillips #00 screwdriver.

13. Remove the battery from the laptop.

14. Do not attempt to remove the screen without first removing the back panel and battery. Ensure that the laptop is powered off before removing the screen
15. Find the hinge bezel where the display bezel meets the back panel.
16. Using an opening pick, unclip the hinge bezel by sliding the pick along the hinge.

17. Using an opening pick, pry open the top, sides, and bottom of the display bezel.
18. Remove the display bezel and set aside.

19. Remove the six golden screws with a Phillips #00 screwdriver and set aside.
20. There are three screws on each side.

21. Remove the two silver screws at the top of the display panel with a Phillips #00 screwdriver.

22. Using an opening pick, carefully pry the screen from top, sides, and bottom of the display panel.
23. Be cautious to not bend or snap the screen as you pry it out.
24. Remove the screen and set aside.