Motorola Moto G Power (2021) Frameless LCD Replacement

ID: 155434

Description: This guide will walk you through replacing the...

Steps:

1. Heat up the back of the G Power with a heat gun or iOpener
2. Once the adhesive has softened, insert an opening pick and slide it carefully around the perimeter of the phone to open it.
3. Do not apply too much heat or pressure when prying. You risk bending the plastic back cover.

4. Remove the 19 Phillips screws shown on the midframe.

5. Use a prying tool to open up the plastic cover plates.
6. If you're using a Jimmy or other metal tool, be careful to not mar the plastic.

7. Unplug the battery connector with a spudger
8. Apply 100% isopropyl alcohol to the edges of the battery. Wait one minute to let the alcohol loosen the adhesive.
9. Pry the battery up carefully. Remove & set aside.

10. heat lcd(can use decent amount of heat to remove)
11. insert opening tool and slide around the perimeter of the LCD to slice the adhesive
12. clean off old adhesive, then apply new glue(either double sided sticky tape or adhesive)

13. plug in new LCD cable
14. insert battery and plug in the battery connector

15. put plastic covers on and screw them in
16. remove most of the old adhesive
17. apply either double sided sticky tape or adhesive glue and put the plastic back cover on
18. if it is not sitting well try to heat it up and press it in a phone press or in between heavy books