GameSir T4 Pro Action Buttons Replacement

ID: 155548

Description: This guide helps you replace the actions...

Steps:

  1. Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).
    2. Step image
  2. Use your iFixit opening tool to break the seam of the back of your controller.
  3. Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.
    4. Step image
  4. Using the plastic spudger, wiggle the connection out of place.
    5. Step image
  5. Apply a slow, but consistent pull to the old 600 maH battery.
  6. Attach new battery onto the pad.
    7. Step image
  7. Remove the three 5mm screws on the motherboard.
    8. Step image Step image
  8. Disconnect all white connectors from the motherboard.
    9. Step image
  9. Carefully pull the motherboard away to reveal the front panel.
    10. Step image
  10. Remove the white rubber panel to get access to the buttons.
  11. Put a small dab of isopropyl alcohol on a cotton swab, and clean around the area of your sticky button.
    12. Step image Step image
Back