Roland TR-505 Switch-board Replacement

ID: 157264

Description: This guide will show you how to replace the...

Steps:

1. With the dials in front of you carefully pull them up and away from the hide and shaft

2. Remove these Philips PH1 screw
3. Not all screws are the same,make sure to keep them organised:-)

4. Carefully separate the 2 half’s
5. If it’s not coming apart you may need a plastic pry tool to assist you
6. Once separated:with the ports facing you open the device like a book with the top panel lifted up slightly,make sure to open it to the right

7. Carefully unplug the connectors from their sockets by pulling on the tabs that stick out from the cable
8. Do not pull on the cable itself as you risk pulling the cables out of the connector

9. with the connectors disconnected you can lift the top half away.
10. to take the switchboard off take out these PH 1 Philips screws
11. Thumbs up to Roland for adding arrows to where the screws are on the switch-board:-)

12. Carefully lift the switch-board out