Bosch Mfq 4020 disassembly

ID: 157479

Description: In this tutorial I'll describe the disassembly...

Steps:

  1. To replace the cable, the housing must be opened.
  2. First unscrew a Torx T15 on the underside.
  3. Then push the bottom panel away in the direction of the arrow (blue).
  4. Then push away the front panel in the direction of the arrow (green).
  5. To divide the housing into two halves, the 3 tabs (red) must be opened. To do this, carefully push the tabs down through the small round holes (yellow arrow). Start with the lower one.
  6. Now it becomes difficult. There is no hole drilled for the 4th tab (green). Use a flat screwdriver to poke through into the joint from under the handle on the right and pry the tab open. Good luck with this. In my case it broke off.
    7. Step image Step image Step image
  7. Here you can see the 4 tabs on the base plate.
  8. You clearly see the tabs on the front plate.
  9. Carefully slide off the two parts as described above.
    10. Step image Step image
  10. Here is an overview of the inner workings of the blender.
  11. These worm gears can still be purchased as a replacement part directly from Bosch or other online providers for approx. 14 €. (Article number 00610702 worm gear) worm gear
    12. Step image
Back