Ersa i-CON 1 Display Replacement

ID: 157625

Description: If your Ersa i-CON Display is broken, use this...

Steps:

1. Pull off the control knob using a nylon spudger.
2. Alternatively, a flat head screwdriver can be used, but be cautious of potential scratches on the metal faceplate.

3. Flip the station over and remove the four T20 screws.
4. Flip the station back onto its base and lift the top cover up and off the station.

5. Use pliers or a wrench to unscrew the four plastic nuts holding the display in place.

6. Carefully flip the display upwards.
7. Loosen the display connector by pushing up the small brown bars on both sides of the connector with a spudger or similar tool.
8. Pull the ribbon cable from the connector.