How to mod the case of a USB Rubber Ducky for a squeeze-to-press button

ID: 158279

Description: The USB Rubber Ducky is a powerful tool for...

Steps:

  1. First remove the the USB-C cap
  2. Jam a flat object, such as your fingernail or a small screwdriver, in between the metal sheath and the Ducky on both sides.
  3. Remove the metal sheath by pulling it off the Ducky.
    4. Step image
  4. Carefully separate the top and bottom plastics by inserting a plastic pick at the seam.
  5. The top and bottom are held together with matching ports and posts.
    6. Step image Step image
  6. "Rain-drop" sticker cutouts can be found along the right side of the included sticker sheet. If you lost your sticker sheet, cut out a sticker of the appropriate size from any label paper or masking tape you have on hand.
  7. Apply two to four layers of the sticker on the inside of the case, directly opposite the button.
  8. The more layers you apply, the easier it will be to press the button. Start with 2-3 layers, then adjust to your preference through testing.
    9. Step image
Back