How to Repair an Anstoy Electric AKM-47 Gel Blaster Battery

ID: 158354

Description: Rechargeable battery packs are common...

Steps:

1. Set your gel blaster flat on a table.
2. Push the battery compartment release tab upwards.
3. Lift the battery cover and remove it.

4. Squeeze both the left and the right side of the release latch and pull apart the connector to remove the battery from the gel blaster's motor.

5. Remove the battery from the battery compartment.

6. Use utility scissors to cut the first green layer of the battery.
7. Remove the first layer to expose the connection to the wire.
8. Be careful when cutting the top layer, and do not remove the inner plastic layer.

9. Using the soldering iron and the lead-free solder, re-solder the wire to the battery to ensure a stable connection.
10. If there is any confusion on how to solder, please refer to the link below: How To Solder and Desolder Connections

11. Insert the battery back into the battery compartment.
12. Reconnect the battery to the motor.
13. Replace the cover to close the battery compartment.