PlayStation 2 Slimline SCPH-900xx Sensor Phalanx Replacement

ID: 160174

Description: Follow this guide to replace the power and...

Steps:

  1. Turn off your PlayStation 2 and remove the disc and Memory Card.
  2. Turn over the PlayStation 2 and put it on a soft surface (e.g. a towel).
    3. Step image
  3. Locate the six covers.
  4. Two are located underneath the feet.
  5. One cover is located underneath the Void sticker.
    6. Step image
  6. Remove the Void sticker with a Spudger and some cleaning alcohol
  7. Removing the Void sticker will void the warranty of your device!
  8. Some versions of that console maybe don’t have the sticker or it’s relocated.
    9. Step image
  9. Remove the covers by using either a Spudger, Opening Picks or your fingernail.
    10. Step image Step image
  10. Remove the six Phillips #1 screws with a screwdriver.
  11. The screws on the right are a bit deeper inside the shell as like the rest but are the same size.
    12. Step image
  12. Separate the clips at the front and the overhanging side from their mounting using a Prying Tool.
  13. Separate the two halves.
    14. Step image Step image
  14. Pull the ribbon cable straight out from the socket.
  15. To reinstall the cable, hold it near the end and push it straight into the connector, being careful not to kink the cable. If you can, apply the force to the plastic reinforcement rather than the cable itself.
    16. Step image Step image
  16. Lift the phalanx up and out of the PS2.
Back