Jabra Elite 85h Charging Port Replacement

ID: 160513

Description: If your Jabra Elite 85h does not charge, it may...

Steps:

1. Remove each ear cushion by hooking your fingers along the inside of the ear cushion and pulling up and away from the ear cup.
2. If the cushion does not fully release, move your hand to the opposite side and pull up inn the same manner.

3. The foam inserts and backing tape are very delicate. Take your time when removing them, and be careful to not rip or tear the material.
4. Using the small plastic spudger to assist, begin lifting up and removing the foam inserts with attached backing tape.

5. Repeat the previous steps for the other side, removing the foam inserts with care.

6. Unscrew and remove the four T6 screws holding the speaker in place.

7. Repeat the previous step for the other side, removing the four T6 screws.

8. Tilt the headphones over so that the speaker tilts out of the plastic holder.
9. Repeat for both sides.

10. Remove the two screws holding the upper and lower circuit boards in place.

11. Remove the two attached circuit boards from the headphone housing.
12. Carefully lift the bar holding the 24-pin ribbon cable in place and remove the cable.
13. Replace entire control board with charge port or de-solder charge port and replace.