Razer Deathadder V3 Pro Skates (Feet) Replacement

ID: 161107

Description:

Steps:

1. Turn off the mouse by holding the power button for 3 seconds.
2. The light on top will blink red, indicating its been turned off.

3. The Deathadder V3 Pro has 4 individual skates on it.

4. Slide your fingernail or a pair of tweezers under the skates and pull up.
5. I found using my finger to finish peeling the skates off was easier, but your mileage may vary.
6. Be careful around the sensor as you could potentially damage it and cause unwanted tracking issues.

7. If there is a leftover paper like material, remove it just like you did the skates.

8. Use the included alcohol prep pad, or your own, to remove any leftover residue.
9. You might have to use your finger to remove some stubborn residue.
10. Let the alcohol dry for a little before continuing.

11. Place your new skates in the correct spot.
12. Apply some pressure with your thumb to make sure that the skates stick properly.
13. Do this for all of them except the sensor ring, that one is discussed in the next step.

14. Use your tweezers or fingers to pop out the extra piece for the sensor ring.
15. When placing the sensor ring skate, be careful not to damage the actual sensor.

16. Enjoy your new mouse skates!