Logitech G Pro X Superlight Scroll Wheel Replacement

ID: 163123

Description: A Logitech G Pro Superlight starts scrolling by...

Steps:

1. Mouse skates will be damaged during this process. Having a new pair of mouse skates is STRONGLY recommended.
2. Use tweezers to peel off the mouse skates on the underside of the mouse.

3. Unscrew the six screws using a 1.6mm Phillips screwdriver on the top and bottom side of the mouse.

4. Open the bottom shell with your hands.
5. Use caution, as wires are still intact.
6. The bottom shell should come off easily without applying any force.

7. Disconnect the wires and cables in contact with the sensor's motherboard.
8. Pull and shake evenly on the cable to make sure cables are not strained. Avoid pulling heavily.

9. Take out the battery located at the back of the mouse.
10. Flipping it upside down helps when removing it.

11. Remove four screws at the bottom part of the mouse with a 1.6mm screwdriver.

12. Carefully take out the left and right mouse buttons.

13. Remove the four screws attached to the scroll wheel.

14. Apply pressure and shake evenly to remove the attached cable.
15. The scroll wheel comes off easily without using too much pressure.
16. Insert the new scroll wheel and line up against the sensor.

17. Reattach the cable.
18. Refasten the four screws.

19. Use a pair of tweezers to reinsert the four screws at the bottom half of the mouse and tighten with a screwdriver.
20. Attach the battery back on the bottom half of the mouse.
21. Reattach the two cables.

22. Line up the bottom shell with the top shell and connect them together.
23. Reapply the four screws back onto the mouse.

24. Put on your new mouse skates.
25. Apply pressure so that they stick to the mouse, leaving no air gap.