Melitta Caffeo Barista T Grinder removal

ID: 163377

Description: These instructions may also help with other...

Steps:

1. Never forget: Remove the cable from the powerplug
2. Remove all the parts

3. The backside is fixed with seven Torx T10 screws. Unscrew them
4. Get the Backside of. It should be a bit stuck.

5. Pull the powder compartment up.
6. Pull one of the sides of the Powder compartment out of the hinge and loosen the lid.
7. Remove the powder compartment

8. In the powder compartment, you should see a rubber cover. Loosen the rubber cover with the appropriate tools.
9. There should also be a Torx T10 screw. Unscrew it

10. The upper cover with the brewing unit is held up from three clamps. These can be reached through a slit.
11. Press these clams with a flat scredriver in and pull the upper cover up, until the clamps loosen.

12. On the side that has a a watertank you can find 2 other clamps
13. Press these clamps with a flat scredriver in and pull the cover up until they loosen
14. Lift the upper cover and the backside up, hook it on the front edge and remove them

15. Push the right and the left side panel back, then pull the lower edge out and pull the side panel out.
16. This could be a bit stuck
17. On the side panel with the watertank, there should be a supply hose attached to a cable that connects the water-level sensore. loosen them
18. Hint: the side panel doesn't have to be removed completely for each repair.

19. Unscrew the 3x Torx T10 screws that secure the bean compartment.
20. Remove the bean compartment upwards.
21. When assembling, make sure that the slider for setting the bean type engages properly.

22. Take out the two foam dampers and the black rubber bean feeder.

23. Unscrew the Torx T10 screw that secures the powder chute.
24. Lift out the powder chute.

25. The grinder is fixed with 3x Torx T10 screws. Unscrew them.
26. Now the grinder is loose. Press it inward a little so that the previously mentioned adjustment lever is free and lift the grinder upward a little.
27. If you want to replace it completely, you still need to disconnect the two cables, if you just want to clean it or replace the grinding stones, it is not necessary.