How to install shower filter for your shower head

ID: 165236

Description: Installing a shower filter for a showerhead is...

Steps:

  1. Ensure your water valve is in the closed position.
  2. Begin by unscrewing the shower head from its original water outlet.
  3. Reminder: You might need to cut off the tape that was previously used for reinforcement. This step might require the use of a wrench for disassembly, so it's recommended to have one on hand in advance.
    4. Step image
  4. Take out the shower filter and rinse it under a faucet (either in the bathroom or any other location) for about 30 seconds to wet the internal filter layer.
  5. This step also helps prevent the shower head outlet from getting blocked by the substances in the filter layer after installation.
    6. Step image Step image Step image
  6. Install the shower filter onto the water outlet by turning it clockwise.
    7. Step image Step image
  7. Turn on the water after installation to check for leaks.
  8. Attention: If there is a leak, wrapping a few rounds of waterproof tape around the joint can effectively prevent it.
  9. Tools: waterproof tape
    10. Step image
  10. Connect the shower head to the shower filter for installation (it's best to use a wrench).
  11. After securing it, check again for any water leaks. If there is a leak, use waterproof tape as before.
    12. Step image Step image
Back