REV Robotics Control/Expansion Hub XT30 Connector (Male/Female) Replacement

ID: 166985

Description: Use this guide to replace the XT30 power in /...

Steps:

  1. There are Phillips #00 screws located at the back of the Control Hub. Two are located behind a sticker, which you will have to poke through or peel off.
    2. Step image
  2. After unscrewing the four Phillips #00 screws, you will need to pry open the plastic housing of the case to expose the circuit board.
    3. Step image Step image Step image
  3. After prying off the plastic case, you should be able to freely remove the board along with the piece of plastic it rests on. Remove the board from this plastic, exposing the electronics.
    4. Step image
  4. After isolating the board flip the board over and locate the XT30 Through Hole Connectors.
    5. Step image
  5. Simply desolder the XT30 you desire to replace, then using either a wick or desoldering iron clean the area.
  6. After this, resolder a new XT30 connector ensuring it is oriented correctly.
    7. Step image
Back