Kurio Motion MotherBoard Replacement

ID: 167312

Description: Is your tablet not accepting charge, won't show...

Steps:

1. Use the Phillips #0 Screwdriver to remove four 5mm screws from sides of the device.

2. Use the Ifixit opening tool to pry open the device to remove the back of the Kurio Motion.

3. Remove the tape covering the tape from the edges of the battery.

4. Remove the orange connectors that are connected to the motherboard by lifting up the white tab, and then gently pulling the connector out.

5. Take out the 5mm screws located at the top right and left of the motherboard.

6. Remove the tape covering the camera gently.

7. Use your spudger to carefully take out the camera.

8. Use your soldering tool to solder the wires that are connected to the battery and the gray wire next them.

9. Use your soldering tool to solder the wires that are connected to the speakers.