Bissell SpotClean ProHeat 5207U Water Pump Replacement

ID: 167999

Description: Is your Bissell SpotClean ProHeat 5207U not...

Steps:

1. Ensure the device is unplugged.
2. Make sure that you have removed both the clean and dirty water tank so that you can unscrew the proper screws.
3. Remove the marked 19.7 mm screws on the underside of the device using the Phillips #00 screwdriver.

4. Remove the plastic top located where the dirty water tank was previously situated.
5. Using the Phillips #00 screwdriver, unscrew the three 17.2 mm screws.
6. Remove the plastic lip that was previously held by the screws.

7. Using pliers, pinch the hose clamp tabs together, then remove the clamp.
8. Remove the water hose from the water pump.

9. Remove the green wire by pulling it away from the pump.
10. Be careful not to bend where the wire is plugged into.

11. Pull the clear hose away from the pump until it is removed.

12. Remove the zip tie from the water pump.
13. Replace the old water pump with the new water pump.