ORFELD EV-660-S222 Power Button Spring Replacement

ID: 168046

Description: The spring inside your ORFELD EV-660’s power...

Steps:

1. Separate the dust cover and the motor from the vacuum body by pressing the eject button.

2. Place the vacuum on its side, with the screws facing towards you.
3. Remove the 11.5 mm screws using a Phillips #1 screwdriver.

4. Using tweezers, remove the sticker connecting the two halves.
5. Use the opening pick to gently separate the top half and the bottom half of the vacuum.
6. Press the blue buttons near the sides of the battery LEDs to remove the top half.

7. Lift the battery slightly to reveal the pin connectors.
8. Gently disconnect the six-pin connector from the battery.

9. Gently pull out the power button from the board.
10. Gently pull up and twist the old spring off of the button.