Auking M8-F PCB Button Panel Replacement

ID: 168100

Description: Use this guide to replace the power panel on...

Steps:

1. Make sure that the device is unplugged from any power source before attempting any repairs.
2. Flip the projector on its opposite side.
3. Remove all six of the 11 mm screws using a Phillips #1 screwdriver.
4. Remove the two 14 mm screws using a Phillips #1 screwdriver.

5. Carefully prop open the top of the projector.
6. Disconnect the cable attached to the top lid.
7. Remove the top lid.

8. Remove the wire cord attached to the top panel to separate both the top panel and the wire cord.

9. Remove six of the 5 mm screws using a Phillips #00 screwdriver to detach the power panel.
10. Remove the power panel.