Merangue Steel 3-Hole Punch Head Replacement

ID: 169536

Description: Over time, the punch head of a hole puncher can...

Steps:

1. Tilt the hole puncher on its back.
2. Use a flathead screwdriver to remove the three screws.

3. Use your finger to slide the punch head out towards the opening (right in this case).
4. Remove the punch head from the opening and set it aside.
5. Repeat this step with the other punch heads.

6. Take your replacement hole punch and push it into the opening.
7. Slide the hole punch to your desired alignment in my case, left).
8. Make sure the hole punch is properly aligned (the hole at the back should point directly at the ceiling).

9. Use your fingers to screw one of the screws into the hole on the back of the punch head.
10. The screw can be a bit difficult to align so be patient and don't rush.
11. Take your flat head screwdriver and tighten the screw.
12. Repeat these steps for the other punch heads.