Shark ION Robot 750 Sensor Replacement

ID: 170593

Description: The Shark ION Robot 750 uses sensors to...

Steps:

1. Make sure the device is completely powered off before working.
2. Flip over the vacuum on a flat and uncluttered service with the bottom facing upwards.
3. Remove all seven 9.1mm Torx T15 screws from the device’s front bumper.
4. Remove the nine 9.1mm Torx T6 bolts from outer shell.

5. Slightly pull front bumper to expose internal wiring.
6. Unplug the device’s front bumper wiring and completely remove front bumper.

7. Remove the four 9.5mm Torx T6 bolts on the yellow brush frame.
8. Gently depress the two tabs on the frame, then lift the frame to remove it.

9. Pick up the brush and remove it from the vacuum.
10. Push the brush to your right and lift it.

11. Press and hold the dust bin removal button to slide out the dust bin.

12. Lift the outer shell to expose the Shark’s interior.

13. Use a Phillips #1 screwdriver to remove the four 11.5 mm screws from the main circuit board.

14. Use a spudger or tweezers to disconnect the white cable connector from the socket on the motherboard.
15. Detach the 17 connectors from the motherboard.
16. For helpful details on disconnecting different types of connectors, check out the Recognizing & Disconnecting Cable Connectors guide.
17. Don't pull on the cables as they might get damaged and affect the function of the vacuum.

18. Pull the outer case away from the robot vacuum to reveal the sensors.

19. Insert the tweezer between the sensor lid and lower shell.
20. Gently lift each sensor up and out using the tweezer.