PDP Rematch Advanced Front Housing Shell Replacement

ID: 170986

Description: The front housing shell should be replaced on...

Steps:

1. Orient the controller so the back side is facing you.
2. Use a Phillips #000 screwdriver to remove the seven 9 mm screws that secure the back shell.

3. Pull apart the controller's front and back shells with moderate force.
4. Orient the controller so that the front shell is facing the floor to prevent the face buttons from falling out.

5. Peel the rubber piece off the back of the face buttons.

6. Push all the face buttons out from the front of the shell.

7. Put two fingers behind the bumpers and push upwards to remove them.