2017 Jeep Cherokee Air Filter Replacement

ID: 171892

Description: Changing the air filter in your 2017 Jeep...

Steps:

1. Pull thehood release lever on the driver's side, under the dashboard until you hear the hood pop open slightly.
2. The hood release is typically marked with a car icon.
3. Walk to the front of the vehicle and reach under the hood to find the secondary safety latch. Slide or lift this latch to fully release the hood.
4. Carefully lift the hood.

5. The engine air filter housing is a rectangular, black plastic box situated near the front left of the engine bay (if you are facing the engine bay).

6. Ensure the engine has cooled down to avoid the risk of burns.
7. Use a Phillips #2 screwdriver to remove the three 8 mm screws securing the air filter housing cover.
8. There are two screws located at the front of the housing and one at the back.
9. Carefully set each screw aside in a safe spot to prevent them from rolling away or getting lost.

10. Lift the cover off the air filter housing.
11. Observe how the old air filter sits inside the housing to ensure correct orientation when installing the new filter.
12. Remove the old air filter by lifting it straight out of the housing.
13. Inspect it for excessive dirt and debris to determine the filter's condition.
14. Handle the old filter carefully to avoid dispersing accumulated dirt.

15. Place the new filter into the housing, making sure it is properly oriented.
16. The filter should fit snugly without any gaps around the edges.
17. Double-check the orientation and fit of the new filter to ensure proper airflow.

18. Place the cover back on the air filter housing.
19. Replace the three 8 mm screws and secure them with the Phillips #2 screwdriver.
20. Ensure all screws are accounted for and tightly fastened to avoid vibrations or unfiltered air entering the engine.