HP 15-g029wm HDD Replacement

ID: 174019

Description: Use this guide to replace the Hard Disk Drive...

Steps:

  1. Unplug any charging cord or accessories connected to the device before beginning.
    2. Step image
  2. Place the laptop bottom-side up on a secure, flat surface.
    3. Step image
  3. Slide each of the two switches that secure the battery to the left.
  4. This will reveal an image of an unlocked lock.
    5. Step image Step image Step image
  5. Use your hands to gently pull the disconnected battery out of the device.
  6. When inserting the new battery, pay special attention to align the battery connections correctly.
    7. Step image Step image Step image
  7. Remove the following Phillips screws on the lower case:
  8. Nine 5 mm
  9. One 6 mm
  10. This will allow the optical drive to separate from the chassis.
    11. Step image Step image
  11. Slide the optical drive directly out of its slot.
    12. Step image
  12. Remove the two 2 mm Phillips screws on the lip of the optical drive slot.
    13. Step image
  13. Use an opening pick to remove the two circular rubber feet near the laptop hinges.
  14. Remove both of the 8 mm Phillips screws.
  15. The screws were hidden by the rubber feet.
    16. Step image Step image Step image
  16. Use an opening pick to pry up and remove the left hinge cover.
  17. Use an opening pick to pry up and remove the right hinge cover.
    18. Step image Step image
  18. Flip the device face up and open the lid.
  19. Insert an opening pick under the keyboard and pry around the perimeter of the keyboard until it fully releases.
  20. Lift the keyboard slightly.
  21. There is a ribbon cable connecting the keyboard to the device on the underside. Do NOT pull it away or you risk ripping the ribbon cable and causing damage.
  22. Use your fingers or an opening pick to unlock the ZIF locking flap that secures the keyboard ribbon cable.
  23. Disconnect the keyboard ribbon cable.
  24. Lift the keyboard off.
    25. Step image Step image Step image
  25. Remove two 5 mm screws using a Phillips screwdriver.
  26. Insert an opening pick in the seam between the top case and chassis.
  27. Slide the opening pick around the edge of the device to separate the top case from the chassis.
  28. Slightly lift the top case up and away from the chassis.
  29. There is a ribbon cable connecting the top plate to the device. Handle with care, and do NOT yank on the ribbon cable to prevent damage.
    30. Step image Step image Step image
  30. Use your fingers or an opening pick to flip up the black ZIF locking flap.
  31. Disconnect the ribbon cable.
  32. Lift off the top case.
    33. Step image Step image Step image
  33. Remove the two 5 mm Phillips screws that secure the HDD.
  34. Pull the HDD slightly to the right to disconnect it, then lift it up and out of the chassis.
    35. Step image Step image
Back