HP Pavilion DV6-6C35DX Hard Drive Replacement

ID: 174287

Description: The hard drive is an important part of the...

Steps:

1. Flip the laptop so the bottom is facing up.
2. Push the sliding latch to the left to release the battery and remove it from the laptop.

3. Push the same sliding latch to the right to release the L-shaped panel.
4. Remove the panel from the laptop.
5. You may need to use a spudger to pry out the L-shaped panel and release any clips before removing it.
6. When reassembling the device, make sure to start by inserting the bottom of the panel first (see image 3).

7. Use a Phillips #0 screwdriver to remove the four 4 mm screws that secure the hard drive.

8. Lift the hard drive out of the slot from the side under the RAM slot.
9. Be careful not to pull on the cable connecting the hard drive to the laptop.
10. Use a spudger to help lift the drive out of the chassis if you are unable to with your fingers.

11. Pull the plastic ribbon attached to the connector to disconnect hard drive from the laptop.

12. Use a Phillips #0 screwdriver to remove the four 4 mm screws on the side of the hard drive cage.
13. When removing the screws, hold the drive cage carefully to prevent the hard drive from falling out.
14. Remove the hard drive from the cage.

15. Disconnect the SATA cable from the hard drive.