Helium FreedomFi 5G Gateway Miner Teardown

ID: 176587

Description: Tearing down the FreedomFi 5g Gateway Miner...

Steps:

1. Front: Power Button, 2x USB-A, Console Port (RS-232 Rollover RJ-45), Antenna Connector (Female RP-SMA)
2. Back: WAN Port (RJ-45), eNB1-3 (RJ-45), Power Light (Red), HDD Light (Green), Grounding Stud, DC Power In (12V 3.3A, Center Positive)
3. Bottom:
4. Model: FFG-HL-4-64
5. Chip FCC ID: 2AF6B-RAK5146
6. Chip ID: 25908-RAK5146

7. Front: 4 Phillips Screws, Retaining Nut on Antenna
8. Back: 4 Phillips Screws
9. Bottom: 4 Phillips Screws
10. All screws are the same length and diameter

11. Note HDMI port on front (Shows console)
12. 12V Power block on back for bare-wire connection
13. Installed Modules
14. RAK LoRa Concentrator - RAK5146
15. Foresee 64GB mPCIe SSD
16. 4GB DDR3 RAM

17. RAM: Lever on either side of chip (Green)
18. LoRa Concentrator: 1 screw on top right (Yellow)
19. SSD: 1 screw on top left (Orange)
20. Main Board: 4 phillips screws at corners (Red)

21. Board: Piesia BT19NE4L (http://en.piesia.com/prod_view.aspx?Type...)
22. Processor: Intel Celeron J1900 (https://ark.intel.com/content/www/us/en/...)
23. Connectors + Diagram (Orange) [HDD light, Power light, Reset switch, Power switch, Speaker]
24. SIM slot (Red)
25. GPIO (Yellow)