Anbernic RG35XX Motherboard Replacement

ID: 178291

Description: The motherboard in the Anbernic RG35xx is...

Steps:

1. Remove the SD card located on the right side of the device by pushing into the SD card slot and pulling the card out.
2. Remove the six 1.2 mm screws that secure the back case with a 2.5 Hex Bit screwdriver.

3. Insert an opening tool into the MicroSD card slot and twist it clockwise to begin releasing the rear case.
4. You'll hear "clicks" as the retaining clips release.
5. Pry around the entire perimeter until the rear case fully releases.
6. Remove the rear case.

7. Use your fingernails or tweezers to gently remove the battery connector from its socket.

8. Disconnect the red audio cable from its motherboard port by carefully pulling the connector with your index finger and thumb or with fine tip tweezers.

9. Remove the six 1 mm Phillips screws that secure the motherboard to the case.

10. Flip up the black ZIF locking flap that secures the bronze ribbon cable.
11. Gently disconnect the bronze ribbon cable.
12. Lift the motherboard up and out the chassis.