Cosori Pro II Power Cord Replacement

ID: 178450

Description:

Steps:

1. Flip the device upside down and remove all of the Phillips #1 screws.

2. Use an opening tool to push on the retaining hooks to disengage them while prying slightly.
3. Remove the panel.

4. Use a Phillips #1 screwdriver to remove all four screws.
5. Lift off the bracket.
6. When lifting this off be careful to not unplug the screen.

7. Use a Phillips #0 screwdriver to remove all the screws connecting to the shell.
8. Dissemble the shell going up to separate the basket holder.

9. Use a Phillips #0 screwdriver and the 150 mm Flex Extension to unscrew the bottom plastic connecting to the basket holder.
10. Be careful to not apply too much force to the metal as it can cause it to warp it, and so it is easy rescrew the plastic piece in place.

11. Pull the bottom shell down pulling at the sides to get them over screw holes.

12. Remove the screws holding the cables into the distribution board with a Phillips #2 screwdriver.
13. Remove the 2 cables that connect the heating coil to the distribution board on the top of the cooking chamber, there should be one blue and one white cable, both with a white shroud leading into the cooking chamber.

14. Flip the device backward so the metal walls appear in a U-shape.
15. Remove the 3 screws inside the cooking chamber that hold the heating coil in place using a 2 Philips screwdriver.
16. Remove the heating coil.

17. Remove the walls of the cooking chamber to get easier access to the fan.

18. Squeeze and disconnect the connectors.
19. Press the tab on the disconnector down then carefully pull it off to remove the wires from the board.

20. Use a Phillips screwdriver to remove the two screws from the motor.

21. Remove the screws securing the heat detector using a Phillips #1 screwdrivers.

22. Using a 3/8" socket, unscrew the hex nut holding the fan in place, making sure to not apply to much pressure on the fan to avoid warping.

23. Remove each piece to the roof of the cooking chamber.

24. Use a Phillips #2 screwdriver to remove the screws securing the motor.
25. Remove the motor.

26. Unhook the wires from the plastic hook.
27. Remove the two Phillips #2 screws that secure the blue and pink cables.
28. Use a Phillips #1 screwdriver to remove the single screw.

29. Use a Phillips #0 screwdriver to remove the two screws that secure the cylinder.

30. Push the cylinder out.
31. Apply force to the hook on the connectors to take off the wires.