Eufy Clean RoboVac G32 Pro Bump Sensor Replacement

ID: 178610

Description: This is a repair guide for the bumper sensor on...

Steps:

1. Orient the device so the underside is facing up.
2. Remove the eight 9.3 mm screws securing the bumper brackets using a Phillips #1 screwdriver.
3. Remove the bumper brackets.

4. Lift the bumper off of the device gently.
5. Use your fingers to disconnect the 8 pin connector.

6. Remove the two 10 mm screws using a Philips #1 screwdriver.

7. Lift the bump sensor off using your fingers.