Epomaker Shadow-X PCB Replacement

ID: 179053

Description: The Printed Circuit Board (PCB) is a critical...

Steps:

  1. Power off the keyboard and unplug any attached cables.
  2. Place the keyboard on a clean, static-free workspace and wear an anti-static wrist strap if available.
    3. Step image
  3. Use a keycap puller to remove all keycaps from the keyboard.
  4. Remove all eight of the hex screws that secure the lower case.
  5. Remove the lower case.
    6. Step image Step image Step image
  6. Locate the PCB, which is mounted below the switch plate.
  7. Disconnect any cables or connectors between the PCB and other components
  8. Remove any screws or clips securing the PCB to the keyboard case. Carefully lift the PCB out of the case.
  9. If there is adhesive or sticky residue holding it, gently work around the edges to release it without damaging components.
    10. Step image
  10. Place the new PCB into the same position in the case, aligning all mounting holes and connectors.
    11. Step image
Back