Marshall Uxbridge Power Port Replacement

ID: 179089

Description: If your Marshall Uxbridge speaker (model...

Steps:

1. Orient your speaker so that the back is facing you.
2. Use a Phillips #2 screwdriver to remove the six 19mm screws from the back plate.
3. Use an iFixit opening pick to remove and lift the back plate to expose the connected wires.

4. Detach the white connector from inside the bottom of the back panel.
5. Detach the small red and white connectors from the motherboard on the left side of the back panel.

6. Pull the blue ribbon cables from the motherboard.
7. Remove the back panel from the speaker base.

8. Use a Phillips #2 screwdriver to remove the two 12 mm screws holding the power port to the back plate.
9. Remove the power port from the back plate.

10. Follow the power port wire and locate the white connector.

11. Unplug the power port cord from the board at the white connector by pushing down on the tab, holding onto the connector, and pulling the connector out.