Doxy Personal Massager Bearing and Screw Replacement

ID: 180696

Description: A visual guide for a manual i created recently...

Steps:

1. Remove silicone head

2. Use T20 Driver to disassemble the cast head

3. Use either prying force, impact, or torsion to break the glue under the metal collar
4. This may damage the collar visibly,
5. This will not stick back together, you will need some rubberised sealant or glue to put it back together

6. Use PZ1 Driver to remove body screws
7. Separate the two halves of the body

8. Gently pry the motor and neck from the body
9. Slide the neck up towards the counterweight

10. Use screwdriver to pry the spring shaft from the motor shaft

11. Unscrew the Spring shaft from the Counterweight shaft

12. Remove the rubber damping collars and keep to hand

13. Use screwdrivers or wedges to remove the two old bearings

14. Press the new bearings into place
15. Be sure to only put force on the center bearing race as pressing from the outside race may damage the bearing
16. using one of the old bearings can help in distributing the load evenly
17. Replace the rubber dampers