Canon EOS Rebel T7i Back Cover Replacement

ID: 181031

Description: Removing the back cover is the first step for...

Steps:

1. Before beginning, remove the battery and SD card from the camera.
2. Using your thumbs, push up on the eyepiece to remove it.
3. Remove the battery door.
4. Open the battery door to about a 35° angle.
5. Pull the battery door straight outwards.

6. Underneath the right I/F terminal cap, remove the following screws:
7. Two M1.7x5.5mm JIS #000 screws
8. On the right side of the camera, remove the following screws:
9. Two M1.7x4.5mm JIS #000 screws
10. On the back of the camera, remove the following screws next to the viewfinder:
11. Two M1.7x5.0mm Phillips #000 screws

12. On the bottom of the camera, remove the following screws:
13. Four M1.7x5.0mm Phillips #000 screws
14. Using a plastic opening pick, partially peel up the top of the back rubber grip.
15. Carefully begin lifting the back cover up away from the camera body.
16. Do not lift it all the way off. There is still a ribbon cable attaching the back cover to the main PCB board.
17. Using a plastic spudger tool, gently pry off the back cover ribbon cable from the main PCB board.