iPhone 16 Pro Max LiDAR Sensor Installation

ID: 181165

Description: Installation steps for the LiDAR sensor in the...

Steps:

1. Lay the LiDAR sensor in its recess.

2. Use a Phillips screwdriver to install the two screws securing the LiDAR sensor:
3. One 1.6 mm‑long screw
4. One 2.9 mm‑long screw

5. Use your finger or a spudger to press and connect the LiDAR sensor connector to the logic board.
6. To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Don't press down in the middle. If the connector is misaligned, the pins can bend, causing permanent damage.