iPhone 16 Pro Max Taptic Engine Installation

ID: 181169

Description: Installation steps for the Taptic Engine in the...

Steps:

1. Lay the Taptic Engine in its recess.

2. Use your finger to pivot the corner bracket down into place.

3. Use a Phillips screwdriver to install the 2.1 mm‑long screw securing the Taptic Engine.

4. Use your finger to gently press the lower assembly cable onto the top of the Taptic Engine.

5. Install the two screws securing the lower assembly cable:
6. One 1.0 mm‑long tri-point Y000 screw
7. One 1.3 mm‑long Phillips screw

8. Use your finger or a spudger to press and connect the two lower assembly cable connectors.

9. Lay the Taptic Engine cover in place and align it by its screw holes.
10. Make sure the bottom edge of the cover latches properly to the frame.

11. Use a Phillips screwdriver to install the three screws securing the Taptic Engine cover:
12. One 2.9 mm‑long screw
13. One 1.3 mm‑long screw
14. One 2.4 mm‑long screw

15. Use your finger or a spudger to press the assembly cable connector onto the logic board.