Shark UltraCyclone CH951 U4 Power Control Board Replacement

ID: 182251

Description: This guide will provide instruction for how to...

Steps:

1. Press the dust cup release button and gently pull the dust cup away from the body of the vacuum.

2. Use a TR9 Torx screwdriver to remove the two 8.7 mm screws previously behind the dust cup.

3. Remove the two 12.2 mm screws underneath the dust cup button using a TR9 Torx screwdriver.

4. Remove the 13.9 mm screw beneath the charging port using a TR9 Torx screwdriver.

5. Use the TR9 Torx screwdriver to remove two 11.6 mm screws that hold the exterior motor in place.
6. They are located underneath where the dust cup previously was and above the exterior motor.

7. Run an iFixit Opening Tool under the casing along the vacuum body until the shell is removed starting around the attachment port, and sliding down towards the charging port.
8. If necessary, apply gentle force.

9. Press down on the connection point of the white wire and disconnect it.
10. The connector looks like a white latch. Push down on the edge to pop it out of place.

11. Remove the 8.7mm screw in the center of the button control board.

12. Remove the board by using your fingers and lifting the component from the body of the device.