PocketBook Touch HD 3 battery replacement

ID: 182471

Description: My e-reader has been lying around for a few...

Steps:

  1. The back cover is only attached with clips and two magnets (green markings).
  2. Place the e-reader in front of you with the back cover facing up. Run a pick along the gap to release the clips. Start in the upper left corner.
  3. Lastly, release the clips on the left side.
  4. Then flip the back cover to the left like a opening book, and the two magnets on the left side are easily released.
  5. Step image Step image
  6. Remove the three pieces of yellow adhesive tape covering the battery and the cables leading to the battery connector. This is best done with the angled tweezers.
  7. The left-hand piece of adhesive tape is stuck down with a little glue. You can peel this off using the pointed end of a spudger.
  8. The other two pieces of adhesive tape are easier to remove.
  9. Step image Step image
  10. The cables to the battery connector are secured with a little glue; remove it with the tip of the spudger.
  11. Now I made a mistake—I didn't know how to remove the connector from the socket and pulled on it with blunt tweezers. That's definitely not the way to do it...
  12. After a few attempts, I was able to remove the connector from the socket by levering it upwards with the tip of the spudger.
  13. Step image
  14. The battery is fairly firmly glued in place. My poor spudger suffered quite a bit, but after some vigorous prying, the battery eventually came loose.
  15. Here you can see the location of the adhesive strips under the battery.
  16. Step image Step image
  17. Insert the battery connector into the socket from above. This was a little difficult for me, so I used the flat end of the spudger to help.
  18. Now test whether the e-reader works and if the repair was successful!
  19. The light comes on, the book opens – everything is fine.
  20. Step image Step image Step image
  21. Now insert the battery and secure it with adhesive tape.
  22. Replace the back cover and press down firmly all around the perimeter so that the clips snap into place.
  23. One of my clips seems to have broken off, but the e-reader still holds together.
  24. And from now on: always take good care of the battery, even if the e-reader is not used for a while. This article explains why this is necessary and how to do it.
  25. Step image Step image Step image
Back