Doss E-GO II Button Receptors Replacement

ID: 184972

Description: Use this guide to replace or fix the button...

Steps:

  1. Peel the backing off of the speaker.
  2. Remove eight 7.9 mm screws using the Phillips #00 screwdriver.
  3. Gently pull apart the grille on the sides of the speaker.
    4. Step image Step image Step image
  4. Remove seven 8 mm screws using a Phillips #00 screwdriver.
  5. Remove six 7.3 mm screws using a Phillips #00 screwdriver.
    6. Step image Step image
  6. Apply a bead of flux.
  7. Press the soldering iron tip firmly to melt the solder.
  8. If you heat the circuit board constantly for more than 10 seconds, the excessive heat may damage the board.
  9. Use tweezers to remove the receptor.
    10. Step image Step image Step image
  10. Use a small piece of solder to attach a new receptor.
  11. Press the tip 2 seconds on each corner to attach the receptor to the board.
    12. Step image
Back