SGIN X15S M.2 SSD Replacement

ID: 184980

Description: This guide is used to replace the M.2 SSD on...

Steps:

1. Remove the eight top and middle 7.3 mm screws using the Phillips #0 screwdriver.
2. Remove the six bottom and side 4.4 mm screws using the Phillips #0 screwdriver.

3. Use the nylon spudger to gently pry a bit of the back panel open. With the opening pick, go all the way around until the back panel is loose.
4. Pull the back panel off the laptop.

5. Gently remove the tape holding the battery's cord to the motherboard, followed by the tape in the middle of the cord.
6. If your battery is swollen, halt this guide and follow the swollen battery disposal guide.

7. Use the nylon spudger to detach the battery from the motherboard.

8. Remove the single 3 mm screw holding the SSD in place using a Phillips #0 screwdriver.

9. Give the SSD a little upward force near the screw side so that it is bent at an angle.
10. Pull the SSD out of its slot.